|
|
| Author |
Message |
papatroll
Joined: 15 Apr 2009 Posts: 100
|
Posted: Sun Nov 08, 2009 9:55 pm Post subject: Psionic Helmet and Dual Well/Plate Radionic Boxes
|
|
|
Question about the helmet: On Uncle Chuckie's website he says the magnets are not needed and that they may be replaced symbolically. Have any of you had any success in just using the Magnetron glued into the helmet? As that it what it looks like to me with the foil circle and the magnets around it. Punch a hole in the middle of it and run the wire from the circle to the crystal on top. There is a Pisionic Amplifying Hat I have seen in another book that uses the Magnetron. Have we determined if the magnets help at all, even a 1% boost? Does the Helmet work after reading Uncle Chuckie's post that the magnets don't help at lest on a "physical" level?
Question about Dual Well Radionic Boxes: Does the witness always go in the right hand can. Will my transmission patterns always go in the left hand can, or will I put any transmission patterns on the target side? Are they better than Single Well Radionic Boxes where everything goes in/on the single can/plate.
I have seen Uncle Chuckie holding a Dual Plate design in one of his videos and he says "It's not being used as a stick pad right now." Does that mean that I could instead of using can for the dual well, use my old tobacco plastic lids pop a couple coils under them and use them as combination stick pads/plates? Would I rub the left one to get a rate for the witness on the right pad and rub the right one to get a reading for the one on the left? Could I just use the right as I am right handed and who ever was left handed could use the other?
Question about capacitors: I am currently using a design which calls for a 10uf capacitor to be soldered to the far posts of the potentiometer and then use the middle post to run the wires. Does that help, hurt? It not "normal" electricity. And after seeing what is inside of them there don't seem to be enough layers to make any decent orgone generators.
Question about crystals: I am using the design in part from the book Basic Psionics which does not have the crystals in it. I have the capacitors instead from another source. Do they help greatly?
Question about Potentiometers and Knobs: I was using 5k ohm potentiometers (radio shack # 271-1714) from another source and find that I always have to cut the shafts or my knobs are way in the air. I have finally just gone with the 25K Ohm Rheostats that Radio Shack sells but they cost a Dollar more. On the plus side they do make cool feeling and sounding "clicks" as they go around the resister. What brand do you use and where do you get them? Anyone found a place to get cheap pre-calibrated knobs?
Any Answers and or comments are greatly appreciated. Thank you for your time.
|
|
| Back to top |
|
 |
|
|
papatroll
Joined: 15 Apr 2009 Posts: 100
|
Posted: Tue Nov 10, 2009 7:43 am Post subject:
|
|
|
|
Ok people are looking but no one is responding. Please any comments are helpful.
|
|
| Back to top |
|
 |
|
|
|